Description
Product Description 2.5M/Roll Universal Car Front Bumper Lip Front bumper lip is a rubber strip that’s affixed to your front bumper, found beneath the bumper, are mainly used to decrease the amount of air going underneath the vehicle to reduce the drag coefficient and lift. Improve vehicle performance and increase grip on the road. Installation Guides: 1. Please keep the surface clean and dry, no sand/dust and put some adhesion promoter (Without) at it before installation. 2. Install the item from the middle, remove protective film from adhesive carefully. 3. Please cut a few triangles in adhesive tape, which is convenient for the turning. 4. Determine exact location of product, align carefully and then press firmly to insure proper adhesion. 5. Do not touch water after pasting within 72 hours. 2.5m (8.2ft) length front bumper lip is free cutting to fit most car application. Such as apply to front or rear bumper, body kit, side skirt, etc. Step 1: Measure the length of the car front bumper area and cut the rubbber bumper anti-collision strip to an appropriate length Step 2: Wash the front bumper area by car cleaner & water to get rid of any dirt or dust, use cloth with isopropyl alcohol to wipe and removes any existing wax so the double-sided tape will stick better; Step 3: Cut the bumper strips to the appropriate length. (Take a hair dryer / heat gun to heat the tape more pliable as well as more adhesive.) Step 4: Take off the red backing the double-sided tape and CAREFULLY line up one side of the bumper lip and slowly make your way by carefully pressing down; Step 5: Use scissors to cut some angles at the bend, it is a tip to help more fit the car edge; Step 6: Finally, just stick the cut corners along the corners.